Printed Printing Requirements

Printed version of the plate. Used to convey the ink to the printed material on the substrate. Multi-layer metal gravure, by the lipophilic copper as the basis of the graphic part, and by the hydrophilic chromium or nickel as the basis for the blank part of the copper or aluminum plate as the base, copper and then plated with chromium or nickel, And then made by the plate version of the printing plate. Diazo resin photosensitive plate (also known as PS version), is a diazonium salt and phenolic resin synthesis of photosensitive liquid, coated on electrolytic and anodized aluminum plate and made, can be stored for six months to one year, for the Yang Plate, Printing Board can be made into a special type of photosensitive plate can also be made of pre-made photosensitive version. The bottom plate of a stained or crimped profile is often made into a tear film version (sheet) which is coated with a resistive layer or a photosensitive layer which can be peeled off or photographed to peel off a special printing plate or film, Printing Board Its sub-coating through the tear film, for the production of map general-stained mask.

Direct printing board is through the automated production line, the surface of the MDF substrate treatment, according to user requirements for a variety of patterns of roller printing a kind of economic plate.

The surface of the printing plate coated with UV for waterproof, wear-resistant treatment of a economical plate. The surface of the direct printing plate is the surface treatment process, Printing Board the surface of the substrate with the filler and the bottom material for the bottom of the substrate to the printing requirements, and then the surface of the substrate printing the necessary wood or pattern.Finally on the surface finishing UV coating, for UV drying. Direct printing board processing technology can be applied to MDF, particleboard plywood and other substrates.

Often, we draw the schematic on the schematic software interface and draw the plate on the printed board interface.

However, sometimes need to analyze and recall the layout of the printed circuit board components, planning, but feel inconvenient. ----- especially the time to drag longer, and more tasks, even more so.

In the printed interface to draw some of the local schematic, Printing Board it will bring a lot of convenience. Moreover, the drawing is not worse than the schematic software.

the way is:

First in the printing plate component packaging library ready to draw the schematic of the special components, you can follow the painting, the course of time this special "schematic library" library will be rich.

Then, use the method of drawing the printed plate to draw the local schematic. The same can be called "special reason library" of the resistance, capacitance, transistor, op amp ... and so on. Near the drawing in the vicinity of the printing plate, the control is very convenient to watch. To switch between.